Hard disk sentinel pro review software#This offset can be positive (the software reports smaller temperature than the real) or negative (the software reports higher temperature than the real). This is called calibration.Īfter the real temperature has measured (by the thermometer or other external temperature sensor), the offset can be calculated by subtracting the value reported by the software from the measured value. To fix this problem, it is possible (and recommended) to measure the actual temperature of the hard disk by using an external infrared thermometer or a front panel with temperature sensor and set the difference between the measured temperature and the temperature displayed by Hard Disk Sentinel (reported by the drive itself) as temperature offset. The difference between the measured and the actual temperature can be 7-9 Celsius degress or even more. The temperature sensor built in most modern hard disks may give improper results. Those Registry settings should now "stick" and not need to be reset again. Then restart HDS, which now will not issue this special function to clear the performance object cache when it detects the change of configuration, so the performance counters will continue working normally - once reset in the Registry. create a new STRING key named DisablePerfCacheClear and specify a value of 1 for that. Hard disk sentinel pro review 32 bit#navigate to HKEY_LOCAL_MACHINE\SOFTWARE\Wow6432Node\HD Sentinel (or HKEY_LOCAL_MACHINE\SOFTWARE\HD Sentinel under 32 bit Windows), where you will see a lot of keys. click "start" (Windows) button and to the search field enter REGEDIT If this happens, you can disable this HDS function as follows: Hard disk sentinel pro review windows#On some systems (regardless of hardware configuration) this function apparently causes the Windows performance monitoring settings in the Registry to be disabled. When this happens, Hard Disk Sentinel has a function that clears the performance object cache and re-detects the performance objects. This was apparently caused by a function in HDS which provides for performance monitoring when a new device - e.g., an external hard disk - is connected/detected. The real time performance monitoring worked per the Registry settings workaround (see earlier edit below), but after some time (for example after connecting/removing external hard disk, pendrive or similar storage device) it stopped working and I periodically had to reset the Registry settings - i.e., the Registry settings change did not "stick". Hooray! This seems to be an effective fix to the episodic real-time performance monitoring issue: Just made a few updates to the Opening Post and added this edit: (I have a quick ad hoc registry fix for that too.) I suspect (but have no proof) that it might be CCleaner as that also seems to be responsible for occasionally knocking out the registry settings affecting xplorer² on my laptop. Something - and I don't see how it could be HDS - is occasionally clearing the registry settings that enable this - they are not "sticky" at any rate. I gave a quick ad hoc registry fix for it - documented in the opening post. When I set them, they were not sticking, so real-time performance monitoring in HDS was not enabled, or kept being disabled.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |